Reduce steps needed to correct transcript errors
in development
P
Paul van der Mey
The number of steps needed to fix each transcript error is too high. Selecting words takes too long and is fiddly (not consistently selected with mouse clicks - has sticky behaviour patterns). Consider:
- making transcription fixes inline rather than inside the current seperate modal dialog box.
- Selecting an area of the timeline and allowing changes by typing there (I accept this probably requires a modal box).
- Removing the 100 character limit on changes.
Gabe Michalski
Built at Telethon — correcting transcript errors will require fewer steps, so you can fix mistakes faster without workarounds. Demo: https://share.descript.com/view/iqaofRb4zi7
Note: pending QA and subject to change before release.
Gabe Michalski
marked this post as
in development
S
StephJ
The number of errors is also very high- sometimes misses entire blocks of dialogue that don't show up at all even though audio volume and quality is same as transcribed.. Very time-consuming to correct.
A
Abhirama Tejas
Remove the 100 character limit PLEASE!!!!